0
0 In Uncategorized

Soldered Necklace Tutorial



 

Even though these necklaces have been around for years I still love my unique hand made treasures and love to pair them now with fun things like skeleton keys or old charms.  Hanging them on ribbon instead of ball chain makes them look more delicate.  I used to teach classes at my little store “Paper Chic Boutique” on how to make soldered necklaces.  The technique is difficult to get down, however, with these simple tips and tricks I have come up with you can be a pro in no time! 

 
Step 1:  You will need a kit.  My kit cost around $150, and I keep it in a plastic tackle box so my items are all together.  You will need glass, copper tape (self adhesive), a clamping system of your choice, flux, boning tool, large piece of glass, power strip, and a soldering tool that heats up to 650 degrees.
 
It is best to solder outside where it is well ventilated.  The fumes from the flux can be dangerous and you do not want to make skin contact at all with the flux.  Please do not solder or have hot tools around small children.  I tape my power strip onto the table so there is no chance of accidental tripping.
 
The large glass goes down on your working surface first.  The hot solder will not stick to it and if it drips you can reuse it.  The hot soldering gun with also not burn through the glass.  This is why it is not only safe but important to use glass as your working mat.  I used glass from an old picture frame.
 
 
Remember that your piece will heat up to 650 degrees, so use your clamps, not your fingers.
 
 
Step 2:  You want to take your cut glass and surround it with copper tape.  Use the boning tool to remove any air bubbles and make cure the tape is nice and secure to the glass.  Cut a small piece of copper tape and use it to adhere the jump ring to the top of your piece.  This trick makes it much easier than building a prong out of hot solder.  Take your q-tip or paint brush and flux your entire piece.  Use your gloves as not to get the flus on your skin.
 
 
Step 3:  Tin your piece.  This means take the solder and simply go around the entire piece with a very thin coat, covering all of the copper wrap.
  
Step 4:  The build up.  So your piece is tinned and you are ready to build up the solder.  It is very hard to get a nice clean line unless you are pretty advanced.  My trick here is about 1/3 from the edge place a large dot of solder (as shown) and let it harden.  Then take the tip of your iron and spread this dot down the long end first and then directly back up and over to the opposite end.  Twirl off end.  Looks great, huh?!  Repeat with all sides.
 
When you get to the top of the piece start the dot on either side of the jump ring and only move to one end. 
 
HUGE TIP:  I find the more you mess with your piece the worse it will look.  Remember you can buff it with the dremel machine.  Try not to wipe it off and start over.  Not only will the piece get too hot and potentially crack, but you may burn through the copper tape.  Do not leave your iron in one spot on your piece.  Simply spread across each side like you are frosting a cake.
 
 
Walla!  All done and ready for buffing with my dremel tool.  I use the stone buffer.  Press down with steady but even pressure and go around each side until nice and shined.
 
These necklaces were made by me for several young ladies in my church to give as birthday gifts throughout the year.  I simply put monograms inside each glass.  I think it would be adorable to put photos inside of your children and it would be fun to make some to hang as ornaments on the tree at Christmas time. 


You Might Also Like

No Comments

Leave a Reply